The best cold saw manufacture in China!

Cold cutting saw operation preparation: start the power supply, wait for the touch screen and control system to initialize; check the status of each part of the flying saw (fixture, speed measuring device), and confirm that there is no abnormality.Cold cutting saw operation: set the pipe diameter, wall thickness and steel pipe length on the touch screen according to the specifications of the production steel pipe; 

measure the parameters of the actual saw blade, input to the touch screen, set the appropriate blade line speed and feed amount; complete the above process After that, the pneumatic oil pump, the feed, the saw blade and the saw car are sequentially tested, and the fixture is tested to see if the state is normal. Simulated operation, when a new specification or overhaul is required, a simulation test is required. Automatic operation, the flying saw will follow the tube speed automatic production run. Stop, in the case of no pipe speed, switch from automatic state to manual state, then stop the oil pump, feed, saw blade and saw car in turn, turn off the power.