Shenyang Contor is a high-tech enterprise specializing in intelligent metal cutting. The cold-cut saw is independently developed by Contor. It uses encoder speed measurement method to track and cut. Therefore, the installation speed of the speed measuring device and the stability of its stability are essential. The general requirements are as follows:1. The speed measuring wheel should coincide with the center of the production line. The upper surface of the speed measuring wheel should be the same height as the lower bus bar of the tube.2. After the whole installation of the speed measuring device is completed, the height of the speed measuring wheel can be finely adjusted by the height adjusting nut to ensure sufficient spring force and good performance of the speed measuring wheel.

3. When producing angled square tubes or rectangular tubes, adjust the distance between the front and rear of the speed measuring wheel by adjusting the speed measuring wheel adjustment sleeve to ensure that the tube is always in contact with the speed measuring wheel.4. the speed measuring device must be regularly checked to ensure that the speed measuring wheel rotates flexibly, the encoder is installed firmly, waterproof, and the bearing is regularly refueled.Doing the installation and maintenance of the speed measuring device will greatly reduce the failure of the cold cutting equipment and reduce the possibility of sawing the saw blade. Moreover, the speed measuring device is the basic guarantee for the precision of the cutting tube length.