The saw cart can not return after the tracing

font: Big Middle Small

The saw cart can not return after the tracing

Released Date: May 16,2025 Article Source: Contor

There is something wrong with saw cart drive motor or the saw cart electric machine.Circuit problem.Cart speed is faster than pipe speed, and the showing length is smaller above 6mm than setting length.

There is something wrong with saw cart drive motor or the saw cart electric machine.Circuit problem.

Cart speed is faster than pipe speed, and the showing length is smaller above 6mm than setting length.

solutions:Change or maintain motor or motor driver.Check the wire between driver and motor and the wire between driver and motor encoder to see if there is open circuit or short circuit.Adjust driver parameters.

Keywords: flying saw tube mill tube cutoff cold saw automatic cold saw

Prev : 300 square CNC milling type flying cutoff contor cold saw

Next : The system can not enter the mode of auto.

News

> News

> Case Demo

Recommend products

: Laser Flying Saw

Shenyang Contor's laser flying saw is used without saw blades, with smooth and burr-free tube cutting quality, which greatly saves the customer's production costs.