The system can not enter the mode of auto.-Contor

font: Big Middle Small

The system can not enter the mode of auto.

Released Date: May 16,2025 Article Source: Contor

The saw cart isn’t at the position of the HOME key light shinning.The line J141 didn’t connect with the motion controller.The line J160 didn’t connect with the motion controller. There are problems or no feedback for cart motor driving, feeding motordriving or cutting motor driving.

solutions:Please put the saw cart backing to the place of the HOME Key Light shinning.Check the data of the I/O operating screen, the Circuit and the switches with the reference of electrical schematic diagram.

Test the saw cart drive motor, the feed drive motor , spindle motor and feedback information line.

Keywords: flying saw tube mill tube cutoff cold saw automatic cold saw

Prev : The saw cart can not return after the tracing

Next : Research on the Precision of Friction Saw Influencing Workpiece Quality

News

> News

> Case Demo

Recommend products

: Flying saw system

Contor flying saw system for friction saw machine control.

: The pipe line system

1.high precision & high EFT 2.response quickly & well synchronism 3.PLC to operate I/O, deep extension and simple wiring.

: laser flying saw

Dedicated for cutting carbon steel, stainless steel, high-strength steel and other tubes.Applicable types of tubes: outer diameter < 219 mm, thickness < 6mm