The best cold saw manufacture in China!

Shenyang Contor Electromechanical Equipment Co., Ltd., specializing in the flying saw industry for more than 20 years, has very rich industry experience. The CTCS series cold-cut saws independently developed by Contor are generally used in the case of proper maintenance. A small failure rate, but what to do when some problems arise?First, when there is a large error in the cutting length of the pipe, first of all, the stability of the speed measuring device should be considered. If there is a problem with the speed measuring device, the speed of the production line displayed on the touch screen will fluctuate, and the Conte cold cutting saw system will have special detection. 

The function page for speed fluctuations. Locations where speed measuring devices may be problematic, including encoders, connecting shafts, and bearings. In addition, length and speed fluctuations may also be problems with machine adjustments and unit drag motors.Second, if the transformer capacity of the workshop is not enough, or the overall voltage is low, the Yaskawa servo used on the cold-cut saw will alarm F10, so when the F10 alarm problem occurs, the power supply voltage needs to be measured first.Third, according to experience, when turning off the power, if a person pushes the saw, it feels very difficult, it is likely that there is a problem with the linear bearing. 

The linear bearing should be inspected in time to avoid damage to the linear guide. In addition, it is necessary to check whether the routing oil is normal.When the device has a sudden problem, first determine the time node of the problem. In addition, it is necessary to observe the problem in detail. When analyzing problems, you can use exclusion, alternative, and other logical thinking. If you would like more details please contact contor@scontor.com